Fractional Distillation Essay

AbstractAn equimolar mixture of cyclohexane and toluene was illogical by unproblematic and computeal distillation, using an empty towboat and a grunter loaf column respectively. Using helium as the mobile phase, the distillate was analyzed through gas chromatography. The calculated HETP for the simple distillation was 8.274 cm/plate and the 3.332 cm/plate for the divisional distillation.Experimental ProcedureA copper packed fractional-distillation column was obtained and an apparatus was assembled for fractional distillation. Four clean, dry fraction collectors were obtained and labeled HETP, fraction 1, fraction 2, and fraction 3 respectively. A majority of 40.0 mL of an equimolar mixture of cyclohexane and toluene was added to a 100.0-mL round fuck flask attached to the end of the distillation column. Heating chips were added to the round bottom flask in enjoin to speed up the heating process. The 100.0-mL round bottom flask, along with the distillation column was atta ched to a ring stand over a heat source. The mixture was delicately heated to a boil. The original five drops were collected in the vial labeled HETP. The liquid for vial 1 began collecting when the temperature was 60 C and continued until it was 85 C. Vial 2 began collecting when the temperature was 86C and continued until it was 99 C. Vial 3 was collected at room temperature once the remaining liquid cooled. A volume of 1 micro-liter of each fraction, including the HEPT was added to the gas chromatography apparatus separately in order for each fraction to be analyzed. For simple distillation, the same procedure was followed using an empty, clean, and dry column.DataTable 1 Simple distillment ValuesVariablesHETPFraction 1Fraction 2Pot ResidueTemp range, C-60-8586-100-Empty Vials & cap, g5.45316.84216.48216.842Vial & contents, g5.57828.32330.21123.311Mass of fraction, g0.12511.48113.7296.469Area GC peak for Cy93.9461.2430.430 congener citizenry Cy, g104.2767.97633.7770% hole Cy9 3.3692.6349.550Actual hoi polloi Cy, g0.116710.6356.8030Actual moles Cy0.001390.126.08080Area GC peak Tol6.684.8730.9874.33Relative mass Tol, g7.0145.113532.52978.047% mass Toluene6.647.3750.45100Actual mass Tol, g0.008384.6156.9266.469Actual moles Tol0.000090.91770.07510.0702Table 2 Fractional Distillation Values (Copper wipe Column) VariablesHETPFraction 1Fraction 2Pot ResidueTemp range, C67-7071-8586-100-Empty Vials & cap, g5.30416.52815.73616.031Vial & contents, g5.41227.14725.26026.200Mass of fraction, g0.10810.6199.52410.169Area GC peak for Cy49.4378.2240.000Relative mass Cy, g54.86786.82444.40% mass Cy99.588.7663.560Actual mass Cy, g0.10759.4256.0530Actual moles Cy0.00130.1120.06570Area GC peak Tol0.19.9022.9457.86Relative mass Tol, g0.10510.39524.08760.753% mass Toluene0.511.2436.44100Actual mass Tol, g0.00051.1943.47110.169Actual moles Tol0.0000050.01290.03760.1103DiscussionThe Northern Pines Chemical Company specializes in manufacturing chemicals from wood products such as turpentine. To obtain pure -pinene, it must be separated, using fractional distillation, from the other major broker turpentine, -pinene. This company would like to switch to a cheaper and longer-lasting boxing material. The objective of this experiment was to separate an equimolar mixture of cyclohexane and toluene by simple and fractional distillation, using an empty column and a copper sponge column respectively. The distillate was analyzed through gas chromatography, using helium as the mobile phase. Helium is a good mobile phase because it acts as an unreactive carrier-gas that pushes the samples through the chromatogram. This information was used to determine which packing material is most effective by comparing HETP values which based on the number of suppositious plates each material provides. Using the copper sponge as packing material in the fractional distillation column provided a very effective separation of cyclohexane and toluene.The calculated HETP for simple d istillation was 8.274 cm/plate and 3.332 cm/plate for fractional distillation. The fractional distillation was more effective because it had a demoralise HETP value which means that it has a higher number of theoretical plates for the same column length as the simple distillation. When comparing the purity of the major cyclohexane-rich fraction with the starting mixture (the equimolar mixture of cyclohexane and toluene) of each distillation the packing material improved efficiency by more than six percent. One way to cure cyclohexane with even greater purity would be to heat the starting mixture slowly and steadily kind of of rapidly, allowing better separation of the components.Another way to improve purity is to make sure the column is justly packed (not too tight) and insulated. Different packing materials will have diverse efficiency for distillation and and so yield different HETP values. The most efficient packing material used was rascing rings, which provided an HETP of 2.67 cm/plate. The copper sponge material had an HETP value of 3.3 cm/plate, followed by glass beads and coiled copper with 7.5cm/plate and galvanized stain with 12.5 cm/plate. Packing the Northern Pines Chemical Companys 3ft fractionating column with rascing rings would provide 34.2 plates, which meets the stripped requirement for separating - and -pinene.Exercises1) HETP=height/platesPorcelain saddles 5 cm= (15 cm )/(x )=3 platesGlass Tube 15 cm= (15 cm )/x=1 plateVigreux Column 8 cm= (24 cm)/x=3 plates gibe plates= 3+3+1-1(boiling flask) = 6 plates2) The HETP value and efficiency of separation can be affected by experimental errors. A) If the HETP sample was collected midway through the distillation, the mole fraction of cyclohexanetoluene would be overmuch lower, which would in turn yield a higher HETP value. B) If all of the liquid distilled within 5 proceedings of heating, a higher HETP value would be found again because all of the toluene would be distilled as well. This also means poor separation. C) If two packed columns were stacked over the boiling flask or else of one, the HETP value remain the same if the columns were identical because the height and number of plates would be the same.